2 complete front LED clear lens signals and color matched mounting plates and connectors. Instructions with photos are also available. Everything will be properly packaged. Example Photos ONLY Below
How do these mount?
These signals have a simple clamp installation. Use the 3 mm clamp to clamp to the fairing. The fairing will not be damaged or modified in any way. Use the included connectors to integrate the wires from the signals to the factory signal harness. Installation takes approx 20 minutes. Some models will require more some less time to install.
Note-This is the fairing plug and not the upgraded signal, but mounts to the fairing the same way and extremely secure.
So These actually will match the paint color on my bike?
YES, they will. If the color is not available for your bike, then often polished or black will still look fantasic.
Why are they more expensive compared to other signals?
Gregg's signals are built with QUALITY, you will see this as soon as you open the package. The mounting plates fit completely flush into the bodywork and all but disappear into the fairing. Each signal weighs approx 1 ounce. For the size, these are some of the heaviest LED flushmounts available. They are manufactured with 6 chip LED technology and sealed from the reverse side with a water proof glue cement compound for durability.
WANT To SLOW Down The Blinking Rate Of GREGG's LED Signals?
Then be sure to ADD Stage 2 Load Resistors to your order.
Why do I need load resistors with my signals?
You do not, but whenever the stock turn signals or filament bulb based turn signals are replaced with LED signals, the signals will flash at a faster rate. Some riders will not mind the faster blinking speed, others will. These resistors are offered for those riders who wish to keep the blinking speed the same as the stock setting. These resistors are very easy to install and do come with detailed instructions.
Want To Make Your Gregg's Signals Dual Functioning Running And Turning Lights?
Then be sure to ADD a "Magic Blinker" to your order.
What is a Magic Blinker?
A Magic Blinker allows these signals to act as running lights at all times when the signals are not engaged. Many stock turn signals are a 3 wire signal which allows them to always shine when the bike is turned on, Dual functioning signals will always be shining the amber light when the bike is running. When engaging the turn signal, these signals will then flash like any other LED signal. Without a Magic Blinker Gregg's Customs turn signals and nearly all other custom turn signals which are a 2 wire signal will not have the running light function, only turn signal function.
Use of this Website constitutes acceptance of the XD Cycle's Ordering Policies
Copyright (c) 2008 Xtreme Discount Cycle LLC. All Rights Reserved.
Produced by Daveworks
